Expert Kitchen Plumbing Services in Ringwood, IL
Whether you're just swapping out a faucet or tackling a full kitchen overhaul with sink relocation, new gas lines, or a pot filler, we handle all kitchen plumbing projects. The size of the job affects the cost and schedule, and sometimes permits are necessary. No project is too small or too involved for our team.
Give us a call at 779-217-8878 and plan to have your plumber involved early—well before cabinets get installed. Moving your sink requires drain and supply work that’s best done when the subfloor is exposed. New gas line installs for ranges or cooktops need to happen before cabinetry goes in, as does pot filler rough-in behind the stove. Early coordination helps everything run smoothly and avoids costly rework.
We also take care of individual kitchen plumbing tasks like faucet installations, disposal repairs, hooking up dishwashers, or adding refrigerator water lines. If you’re remodeling, it’s wise to check if your water heater can support increased demand and clear out any slow drains before closing everything up. Reach out at 779-217-8878 for all your kitchen plumbing needs.
Our Kitchen Plumbing Offerings
Sink and Faucet Installation
We handle every kind of kitchen sink installation—whether undermount needing precise countertop cuts, drop-in, farmhouse style, or prep sinks. We install all the components: strainers, drain baskets, P-traps, and connect the water supply lines with durable braided stainless steel tubing, not brittle plastic. Need a garbage disposal installed too? We’ll take care of that in the same visit whenever possible.
Faucets come in many styles and mounting configurations—1-hole, 3-hole, or deck plate—and we install and pressure-test them carefully. If you’re moving your sink to a new spot, that means rerouting drains, adjusting venting, and running new water lines. We handle those permits and inspections as part of the job.
Dishwasher and Appliance Hookups
When hooking up a dishwasher, we connect the hot water line, route the drain hose with a proper high loop or air gap to prevent backflow, and make sure the electrical setup is ready (we coordinate with electricians on that). For fridges with ice makers or water dispensers, we install a dedicated cold water line with a convenient shutoff valve behind the unit, using copper or braided stainless lines securely fastened.
We also install instant hot water dispensers, under-sink filtration systems, and reverse osmosis units—drilling a dedicated faucet hole when needed and connecting all supply and waste lines. Maintenance tips for filters? We’ll walk you through it. Call 779-217-8878 for any kitchen appliance plumbing hookup.
Gas Line Installation for Cooking Appliances
Switching to gas or adding a cooktop in your kitchen island? We size the gas line to fit your appliance’s BTUs, route it safely from your gas main, install a shutoff valve, connect with flexible code-approved fittings, and pressure test everything. Permits and inspections are part of the process too. Visit our gas line services page to learn more about our safety standards.
Important: new gas line rough-ins to islands or new locations have to be done before cabinets go in. Trying to add lines after cabinetry is installed means tearing things apart and more expense. Talk to your GC and us early to avoid headaches.
Pot Filler Faucet Installation
Pot fillers let you fill pots at the stove directly, saving trips back and forth to the sink. We run a cold water supply line inside the wall at about 56–60 inches from the floor, just off-center from your range. It’s easiest to install during remodels with open walls but possible in finished kitchens with minor wall work. We’ll help you find the best approach for your setup. Call 779-217-8878 to talk it over.
Island Sink Plumbing and Drain Venting
Island sinks require special venting since they can’t tie into a wall vent stack normally. We install an island loop vent or an air admittance valve (AAV) as per local code. Running hot and cold supply lines is straightforward, but the drain and vent piping underneath the floor needs careful routing. We’ve done plenty of these complex installations and can guide you through your island’s plumbing layout before finalizing your design.
Kitchen Plumbing Tasks Checklist
- Removal and installation of all sink types (undermount, farmhouse, drop-in)
- Faucet installation, any style or mounting configuration
- Garbage disposal installation or replacement
- Dishwasher water supply and drain connections
- Refrigerator ice maker line installation
- Gas line installation for ranges, cooktops, ovens
- Pot filler faucet rough-in and setup
- Under-sink water filtration and reverse osmosis systems
- Island sink drain and vent system installation
- Upgrade of shutoff valves throughout the kitchen
- Installation of prep or bar sinks in pantry or island
When to Schedule Kitchen Plumbing Work
- Sink location confirmed before demolition: Relocating the sink is the priciest plumbing change, so lock this in before ordering cabinets.
- Gas line installed before cabinetry: Running gas to a new location or island must happen prior to cabinet installation.
- Pot filler before backsplash: It’s much easier to open walls before tile goes up behind the stove.
- Upgrade shutoff valves while accessible: Older gate valves tend to fail; swap them for ball valves when plumbing is exposed.
- Run refrigerator water lines before counters: The ice maker line is simpler to install before countertops are set.
Kitchen Remodeling FAQ
Yes, although it’s one of the more complex plumbing projects due to venting requirements like an island loop vent or air admittance valve (AAV). Water supply lines are straightforward, but routing the drain and vent pipes takes planning. We install island sinks often—call 779-217-8878 to review your layout before final decisions.
If you’re just replacing fixtures like faucets or disposals in the same spot, typically no permit is needed. But any changes involving new drain lines, supply rough-ins, gas lines, or repositioning plumbing require permits and inspections. We handle all the paperwork and inspections for you.
Absolutely. It’s best to do it while walls are open during a remodel. We install properly sized, pressure-tested gas lines for ranges, cooktops, and ovens, and take care of permits. Make sure to schedule this before cabinets are installed to avoid costly rework.
We do. We serve as plumbing subcontractors on kitchen remodels, coordinating closely with general contractors to fit our work into their schedule and manage permits. Contact us early at 779-217-8878 to ensure smooth collaboration.